Hamboards Hst 2.0 Flow Kit mm Longboard Truck

Essentially we changed the design by adding a compression bushing "inside" our strongest spring so that the wave cams and hanger squeeze it against the baseplate when you turn. This is such a big idea and makes such a difference to the ride, that we applied for a new patent.   The HST 2.0 Flow Kit is much more than just a bushing The big idea started with placing a bushing (red above) inside the spring, but it didn't end there. We revisited every other component in terms of design, specifications and materials. In doing so, we developed new fiber-reinforced nylon wave cams that are incredibly strong. The materials, processing conditions and dimensions of the kingpin, washers and cam keys have been optimized. It's all dialed-in. In short, we rethought the entire internal system to raise our HST Trucks to a new level of performance. With this Flow Kit, you'll feel more connected, more stability and still experience the full range of board lean that you've come to expect from an HST Truck. This Flow Kit will change your ride so much you that will feel it immediately. It'll be like you're on brand-new trucks. With it, you will experience: Greater stability Precise handling A wide range of tunability/adjustability   Make Your HST Trucks Feel Better Than New This kit is contains all the components to service two trucks and is compatible with all HST Trucks. It consists of: Two of our 85mm kingpins, with precisely the right number of threads to avoid over-tightening the trucks. Two each of our molybdenum impregnated nylon washers, which are self-lubricating, tough, and virtually silent. Two sets of our fiber-reinforced nylon wave cams with the cam key permanently bonded to one side. Two of our cast polyurethane cone bushings that fit perfectly into the space between our hanger post and the baseplate. One kingpin hex tool to assemble and adjust your trucks. One packet of wave cam lubricant (3cc) If your HST Trucks are more than five years old, we recommend you use new gold springs to ensure you get the most performance out of your "new" trucks.   Adjust Your HST Trucks Like You Never Could Before When you assemble your trucks with the Flow Kit, just tighten the king pin until it starts to show through the nut. After you ride it a bit, you can tighten the king pin for more stability. You will be amazed at the range of adjustment. Our Flow Kit is compatible with all versions of HST Trucks and Original Skateboards S8 trucks, which we used to install on our boards.

Specs