E6000 Plus Craft Glue

INSTRUCTIONS

Follow these step-by-step directions when using E6000 PLUS:

Read directions and test small area for adhesion before use. Surface should be clean, dry and free of dirt. For best adhesion on smooth, non-porous materials, lightly roughen surface before use. Ideal application temperature range is 50 to 90 ºF (10 to 32 ºC). Once fully cured, the adhesive can withstand temperatures from -40 to 200 ºF (-40 to 93 ºC) intermittently.

Puncture seal in neck of tube using pointer cap.

Apply directly to surfaces to be bonded or repaired. NOTE: For non-porous surfaces, apply adhesive, mate surfaces together, pull apart for 5 minutes, then re-mate surfaces permanently.

To close tube properly,remove air in the tube by squeezing product slightly past end of the opening, then tightly recap. Dried product can easily be removed.

Allow 24 hours for full cure. Depending on substrates and temperature, maximum bond strength may not be reached for up 72 hours.

Clean uncured adhesive with rubbing alcohol, mineral spirits, acetone or a dry cloth. Cured material may be removed with mineral spirits or by cutting or scraping.

Not recommended for use on acrylic, vinyl, foam, polyethylene and polypropylene. Store in a cool, dry place.

Tip: For quick emergency repairs, lightly mist the substrate with moisture prior to applying adhesive.